| |
|
CMAK-4G
( 4G LTE Data Card Accelerator Kit ) |
- Full Band (698 – 2700 MHz) Broadband CM288W antenna
- Omni-directional antenna 3-4 dB Gain.
- Easy to install
- CM004-20-FN 20 ft white cable and CM004-20-FF cable
- PanTech 4G data Card adapter cable
- User guide with easy to use installation instructions
|
|
This accelerator kit is a low-cost solution that increases the 4G signal where you need it most – indoors. It comes with a CM288W full band antenna, cables and adapters that connect to your 4G LTE data card so that you can amplify a weak signal (or no signal at all) and get 4G service.
|
|
Frequency
|
698-960/1700-2700MHz |
Input Impedance
|
50 ohm |
Antenna Gain
|
2-3dB at 698-960 MHz
3-4dB at 1700-2700 MHz |
VSWR
|
≤1.8 |
Power Rating (W)
|
10 |
Polarization Type
|
Vertical |
Radiation
|
Omni-directional |
Maximum Power
|
100 Watt |
Connector type
|
N-Female or based on customer request |
Dimension
|
9.5” x 3.9” |
Color
|
White |
Operating Temperature
|
-22° F Degrees to +176° Degrees |
Mount
|
Mounts on roof or wall |
Beamwidth
|
E:72 H:92/ E:50 H:80 |
Groundplane
|
Built-in ground plane |
Material
|
Fiberglass |
|
|
The 4G LTE Data Card Accelerator Kit comes with a CM288W Omni-directional antenna. Omni-directional gather signal from all sides and does not need to be pointed toward the tower. For best results, the antenna should be mounted in an upright position. Follow installation instructions in the user guide to achieve the maximum benefit out of this 4G LTE Accelerator Kit.
Mounting Details:
The CM288W Full Band Fiberglass antenna includes mounting equipment to mount to either a flat horizontal surface or a wall. It should be mounted in an upright position.
.
|
